University of Calgary Sump Pump Causing Flooding
Water was flooding a mechanical room through the wall penetration for a sump pump's discharge pipe whenever the pump turned on. The two (2) inch discharge pipe ran underneath lecture halls at a university. Revive Pipes installed a Cured in Place Pipe (CIPP) liner in the pipe to seal up the separated joints and prevent the deluge of water into the mechanical room whenever the pump turned on.
A building on the University of Calgary campus was having a problem with their ground water sump pump. Every time the sump pump kicked in, a deluge of water would come back into the mechanical room through the discharge pipe penetration in the foundation wall of the building. Upon inspection, it was revealed that the two (2) inch discharge pipe had several joint separations before it reached the main storm sewer approximately fifty (50) feet outside of the building. Unfortunately, the separations in the pipe were all underneath classrooms and high use areas in the building.
Typical Invasive Repairs
The university maintenance staff was looking at having to saw cut and jackhammer through the floors in hallways and classrooms and excavate down to the discharge pipe to replace it. It would have been extremely expensive and disruptive to the continuously used facility.
contractor time on site
Revive Pipes Solution
Revive Pipes skilled team cleaned out the pipe and installed a two (2) inch liner inside of the discharge pipe that completely covered and sealed the separated joints. We didn’t have to make any excavations inside of the facility and all of the work was completed using existing access points in the piping system.
Revive Pipes Cured in Place Pipe (CIPP) Lining Services
Revive Pipes skilled technicians are specialists at installing cured in place pipes (CIPP) in complex configurations with a key focus of minimal client disruption.
We can install 1 1/2 inch and 2 inch liners in pipes using existing access points in the system without having to make any access pits.